Difference between revisions of "Pulse System Description"

Revision as of 10:39, 15 June 2017

Overview

The Vingtor-Stentofon Pulse system is a SIP intercom system intended for small to mid-size installations for up to 64 IP stations. Some of the key features of Pulse are:

Easy to install and configure
Cost effective for solutions where up to 64 IP stations are needed in the network
Supports creating Pulse trunks to inter-connect up to 50 different Pulse systems
Single Pulse system works across multiple network subnets
SIP Gateway interface that is easy to setup (e.g. SIP-to-GSM, SIP-to-PSTN, etc.)
Open IP standards (SIP, HTTP(S), NTP, SNMP, RTP, etc.)
Shared network infrastructure with other systems (CCTV, PCs, etc)
Special SDK with API that can be used to create custom intercom solutions
Integrated managed switch in terminals
Wide set of special purpose IP stations and PC client
VS-IMT: Dedicate management tool for easy configuration of large number of stations

Pulse server functions

Specifications

Protocols and network ports

Reserved IP addresses and ports

Dialing method

Gateway interface and external communication

Support for 64 stations

Station auto-discovery and configuration

Multi-subnet support

Network with multiple Pulse systems

Server Call Forwarding

Pulse trunking

Pulse Trunking is a feature in the Pulse Server for enabling calls between different Pulse sites. The function is enabled with Pulse-Server-Enterprise license. A total of 50 trunk routes can be configured on the Pulse server.

Pulse Trunk Routes must be configured to enable calls between different Pulse sites. A route consists of:

Number range for the site the route goes to
Logical name for the route
IP address and SIP port of the remote Pulse Server on the remote site (Pulse Server SIP port is normally 5060)
Profile to assign calls coming from/to the route. Profiles can be used to restrict access to/from a route

For two sites to call each other 2 routes must be configured. First, a route must be configured in Pulse Server 1, the route must define the number range of Pulse site 2 and the IP address of Pulse Server 2. In addition Pulse Server 2 must have a configured route to Pulse site 1, with the number range of Pulse site 1 and IP address of Pulse Server 1.

If only 1 route is enabled, site 1 with the Enterprise license can call site 2, but site 2 cannot call site 1

Example of Pulse Systems interconnected by Pulse Trunking

A client may only call to sites where there exists direct routes. In the example, the Remote sites may only call Central site, because only a route to Central site is configured. The Central site may call all of the Remote sites because it has routes configured to each Remote site. Configuration example for Central site Pulse server: