Difference between revisions of "Substations calling external telephone(s)"
From Zenitel Wiki
(→AudioCodes MP114/118) |
|||
Line 67: | Line 67: | ||
* In the '''Tel Profile Settings''' page, select the Profile ID number, and set ''Dialing Mode'' to 'One-Stage'. | * In the '''Tel Profile Settings''' page, select the Profile ID number, and set ''Dialing Mode'' to 'One-Stage'. | ||
− | [[File: | + | [[File:MP114 OneStage TelProfile.PNG|left|thumb|500px|'''Configuration''' tab > '''VoIP''' menu > '''Coders and Profiles''' submenu > '''Tel Profile Settings''' page item]] |
<br style="clear:both;" /> | <br style="clear:both;" /> |
Revision as of 15:54, 24 August 2018
This article describes how substations in the AlphaCom can be configured to call external telephone number(s).
- If all lines in the SIP gateway are busy, the call will be queued. When the line becomes free, the call will automatically progress.
- Multiple phone numbers can be defined. If the first phone doesn't answer within a preset time, the call can be routed to a second (and a third...) phone number.
The AlphaCom and SIP Gateway must be configured to use One Stage (Enbloc) dialing to achive the described functionality |
Contents
Prerequisites
The AlphaCom and SIP Gateway must be configured as described in relevant articles.
Configure the Call Button of the substation
The call button can be configured in two different ways to dial a preconfigured phone number.
Let's assume that the prefix to the external phone line is "0", and the phone number to call is 987654321.
Alternative 1:
Start the string with a "I", followed by the prefix number "0". Then "P", followed by the phone number.
Alternative 2:
Start the string with a "T", followed by the prefix number "0". Then "w" or "W", followed by the phone number. "w" introduces a 0.5 second pause, while "W" introduces a 1.0 second pause. See Play DAK Feature for further details.
Configure the Prefix Number
One Stage dialing ("enbloc dialing") must be used. The digit are collected in the AlphaCom and sent to the SIP gateway in the INVITE message. The prefix number must be programmed in the AlphaCom directory table with Feature 81 and Node = SIP Trunk node number. In the "Parameter 2" field you must enter the maximum number of digits in a phone number.
When the prefix is dialed, the AlphaCom will collect the number of digits specified in the “Parameter 2" before sending the INVITE. If fewer digits are dialed, the AlphaCom will send the INVITE after a predefined timeout. The timeout is by default 3 seconds, and can be configured in Exchange & System > System VoIP: SIP digit collection timeout. The call setup time will be faster if this timer is set to a low value.
Set SIP Gateway in One Stage dialing mode
GSM Gateway MV370
Set the GSM Gateway to One Stage dialing mode by selecting Route > LAN to Mobile Settings. Set "URL" = * and "Call Num" = #:
AudioCodes MP114/118
The AudioCodes gateway should be configured as described earlier in this article, but with the following modifications and additions:
- In the FXO Settings page, enable 'One-Stage' dialing, 'Wait for dialtone' and 'Answer Supervision'.
- If the FXO lines are assigned to a "Telephone Profile ID", you need to modify that particular "Telephone Profile ID".
Check in the Endpoint Phone Number Table page if the FXO line is assigned to a "Telephone Profile ID":
- In the Tel Profile Settings page, select the Profile ID number, and set Dialing Mode to 'One-Stage'.