Difference between revisions of "Tamper switch"
From Zenitel Wiki
| Line 2: | Line 2: | ||
== Configuration == | == Configuration == | ||
Create this event for the Tamper Switch: | Create this event for the Tamper Switch: | ||
| − | [[file:TamperSwitchEvent.png|500px|thumb|Tamper Switch configuration]] | + | [[file:TamperSwitchEvent.png|500px|thumb|left|Tamper Switch configuration]] |
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
Revision as of 10:08, 27 March 2020
Configuration
Create this event for the Tamper Switch:
Mounting
Mounting instruction on Tamper Switch for IP Vandal Resistant Substation TKIE
Step 1: Remove the two nylon nuts shown below
Step 2: Attach the supplied spacers
Step 3: Mount the tamper switch board
Step 4: Move the button GND wire from the the TKIE board to the tamper switch board
Step 5: Use the supplied wires to connect GND and Input 3 as shown below
