Difference between revisions of "Tamper switch"
From Zenitel Wiki
(→Configuration) |
|||
| Line 4: | Line 4: | ||
==Configuration== | ==Configuration== | ||
| + | === For a single station == | ||
In [[AlphaPro]], create this event for the Tamper Switch: | In [[AlphaPro]], create this event for the Tamper Switch: | ||
[[file:TamperSwitchEvent.png|500px|thumb|left|Event handler configuration]] | [[file:TamperSwitchEvent.png|500px|thumb|left|Event handler configuration]] | ||
| Line 14: | Line 15: | ||
[[file:TamperSwitchWeb.png|500px|thumb|left|Advanced AlphaCom -> I/O Settings]] | [[file:TamperSwitchWeb.png|500px|thumb|left|Advanced AlphaCom -> I/O Settings]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
| + | |||
| + | |||
| + | === For all stations == | ||
==Mounting== | ==Mounting== | ||
Revision as of 13:40, 1 December 2022
The IP Vandal Resistant Substation with TKIE has the possibility to be fitted with a tamper switch. Making it possible to raise an alarm if the station is dismounted from the backbox.
Configuration
= For a single station
In AlphaPro, create this event for the Tamper Switch:
Action commands:
$STM L110 L101 U100 'TAMPER CELL 10'
The IP Substation must have I/O number 3 defined as an input (default).
= For all stations
Mounting
Mounting instruction on Tamper Switch for IP Vandal Resistant Substation TKIE
Step 1: Remove the two nylon nuts shown below
Step 2: Attach the supplied spacers
Step 3: Mount the tamper switch board
Step 4: Move the button GND wire from the the TKIE board to the tamper switch board
Step 5: Use the supplied wires to connect GND and Input 3 as shown below
