Difference between revisions of "Turbine+ series board connectors"
From Zenitel Wiki
| Line 14: | Line 14: | ||
| 3 || I/O interface|| 5.3V (200mA max) output and GND, and 6 x I/O connectors . Typically used as digital input (eg. from a closing contact) or digital output (12mA LED driver). | | 3 || I/O interface|| 5.3V (200mA max) output and GND, and 6 x I/O connectors . Typically used as digital input (eg. from a closing contact) or digital output (12mA LED driver). | ||
|- | |- | ||
| − | | 4 || Line Output || 600 ohm balanced line out. Suitable e.g. for induction loop amplifier. | + | | 4 || Line Output || 600 ohm balanced line out. Suitable e.g. for an induction loop amplifier. |
|- | |- | ||
| 5 || Speaker Output || Connection for 8Ω external speaker (relevant for [[TKIV+]] kit) | | 5 || Speaker Output || Connection for 8Ω external speaker (relevant for [[TKIV+]] kit) | ||
Revision as of 08:17, 9 June 2023
| Item | Description | Comment |
| 1 | USB Port | Used only during production process, or for recovery. |
| 2 | Relay | NO/NC relay. |
| 3 | I/O interface | 5.3V (200mA max) output and GND, and 6 x I/O connectors . Typically used as digital input (eg. from a closing contact) or digital output (12mA LED driver). |
| 4 | Line Output | 600 ohm balanced line out. Suitable e.g. for an induction loop amplifier. |
| 5 | Speaker Output | Connection for 8Ω external speaker (relevant for TKIV+ kit) |
| 6 | Microphone Input | Connection for electret microphone (relevant for TKIV+ kit) |
| 7 | Power Input | 24 VDC for external secondary power if PoE/PoE+ is not available. Pin 1 is positive. |
| 8 | Network Port | 10/100/1000Mbps RJ-45 port connecting to Ethernet. PoE/PoE+ is supported. |
| 9 | SD-card slot | SD Card slot planned for future use. Currently not in use. |
|
|