IP Flush Master DAK-48 Module

DAK-48 Unit. Item number: 1008010100

The IP DAK-48 unit expands the:

• IP Flush Master -V2
• INCA IP Flush Master Station

with an additional 48 Direct Access Keys. Up to two DAK-48 units can be connected to one station.

Software and license requirements

Software:

• IP Flush Master (INCA): Version 01.09.3.0 or later
• IP Flush Master (Turbine): Version 6.0.3.0 or later
• AMC-IP: Version 10.60.3.0 or later

License: To enable the use of the DAK48 module a license is required:

• 1009648001: License for CRM-V DAK expansion

Regardless if the CRM-V station is using one or two DAK48 modules, only one CRM-V DAK expansion license is required.

The DAK-48 module is supported in ICX-AlphaCom mode only, not in Edge, Pulse or SIP mode.

Installing the DAK-48 Expansion module

To interconnect the DAK-48 unit to the main unit, use the cable which is coming with the DAK-48 unit. The DAK-48 unit receive its power and data via this cable.

A standard patch cable (1:1) must not be used. It might damage the unit!

Installing the IP DAK-48 Unit:

• Power off the IP Flush Master station by disconnecting the ethernet cable in the LAN port
• Plug one end of the cable coming with the DAK-48 unit into the RJ45 port on the right hand side of the IP Flush Master station (when the station is viewed from the front).
• Plug the other end of the cable into the left RJ45 port on the DAK-48 unit (when the unit is viewed from the front).
• Power up the IP Flush Master station by connecting the ethernet cable to the LAN port

To add a second DAK unit, plug one end of an RJ45-RJ45 cable into the RJ45 port of the installed unit and plug the other end into the RJ45 port of the new unit.

Related articles

• Dimensions
• Back box on wall mount - 1008098600
• Back box flush mount - 1008098700
• AlphaCom DAK expansion license 1009648001
• Licenses for ICX-500 and ICX-AlphaCom Core
• Additional Documentation on Zenitel.com

Related products

• Label Paper for IP DAK-48 Unit - 1008010101 (1 sheet)