Operating the TEIV-1+: Difference between revisions

Revision as of 04:37, 4 June 2024

To make a call – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence
To make a call using address book – use the checkmark after selection is done
To activate a relay from keyboard - Press the # key, followed by your 4 - 10 digit Pin Code.

To make a call – you need to press “#” followed by the number to be called to and then the checkmark (v), e.g. # 201 v
To make a call using address book – use the checkmark after selection is done
To activate a relay from keyboard, you need to press a pin code (e.g. 4 digits).

To define a pin code – create a csv file with 4 digits numbers as shown in the example below:

A maximum of 30 pin codes can be uploaded
When saving the CSV file the seperation character should be defined as semicolon (;).
Upload the pin code list file under the Address Book menu as shown below

Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control

Make sure port 8080 port in the device firewall is opened

@@ Line 1: / Line 1: @@
 {{AEIS}}
 == Making a call ==
+===Since VS-IS 8.2.3.1===
+* To make a call – Dial the wanted extension number on the numeric keypad.  In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence
+* To make a call using address book – use the checkmark after selection is done
+* To activate a relay from keyboard - Press the # key, followed by your 4 - 10 digit Pin Code.
+===Prior to VS-IS 8.2.3.1===
 * To make a call – you need to press “#” followed by the number to be called to and then the checkmark (v), e.g. # 201 v
 * To make a call using address book – use the checkmark after selection is done