Difference between revisions of "Operating the TEIV-1+"
From Zenitel Wiki
(→Making a call) |
|||
Line 15: | Line 15: | ||
− | == | + | == Using the station == |
===Since VS-IS 8.2.3.1=== | ===Since VS-IS 8.2.3.1=== | ||
− | * | + | * '''Making a call''' – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence |
− | * | + | * '''Call using address book''' – use the check mark after selection is done |
− | * | + | * '''Door Opening''' - Dial #, followed by your Pin Code. This will activate the built-in relay. |
===Prior to VS-IS 8.2.3.1=== | ===Prior to VS-IS 8.2.3.1=== |
Revision as of 12:39, 20 June 2024
Contents
Defining PIN code(s)
- To define a pin code – create a csv file with 4 digits numbers as shown in the example below:
- A maximum of 30 pin codes can be uploaded
- When saving the CSV file the seperation character should be defined as semicolon (;).
- Upload the pin code list file under the Address Book menu as shown below
Encrypted pin codes are stored here: http://[IP address of the station]:8080/state/config/gui/door_access_control
Make sure port 8080 port in the device firewall is opened |
Using the station
Since VS-IS 8.2.3.1
- Making a call – Dial the wanted extension number on the numeric keypad. In SIP Mode, the Check mark may be required to indicate the end of the dialing sequence
- Call using address book – use the check mark after selection is done
- Door Opening - Dial #, followed by your Pin Code. This will activate the built-in relay.
Prior to VS-IS 8.2.3.1
- To make a call – you need to press “#” followed by the number to be called to and then the checkmark (v), e.g. # 201 v
- To make a call using address book – use the checkmark after selection is done
- To activate a relay from keyboard, you need to press a pin code (e.g. 4 digits).