Difference between revisions of "Network Interface Configuration (Zenitel Connect Pro)"
From Zenitel Wiki
(Created page with "{{C}} ==Introduction== Network Interface configuration is done from the tile '''Networks''' in the '''System''' section. An ICX-510 has tw...") |
|||
| Line 53: | Line 53: | ||
* '''Hardware Address''': The MAC-address of the interface | * '''Hardware Address''': The MAC-address of the interface | ||
| − | [[Homepage (Zenitel Connect Pro) | + | [[Homepage (Zenitel Connect Pro)]] |
| + | |||
| + | |||
[[Category: Zenitel Connect Pro]] | [[Category: Zenitel Connect Pro]] | ||
Latest revision as of 16:41, 22 October 2024
Contents
Introduction
Network Interface configuration is done from the tile Networks in the System section.
An ICX-510 has two network interfaces which can be configured, a Virtual Machine has minimum of one network interface.
 |
| Network configuration |
ICX-510 - default configuration
The two network interface of the ICX-510 are labeled Eth0 and Eth1. The default configuration is:
- Eth0: Static IP-address: 169.254.1.5/16
- Eth1: DHCP
|
All IP addresses are given in CIDR notation |
Virtual Machine - default configuration
A Virtual Machine may have multiple network interfaces. All interface are configured as DHCP.
Network interface options
Each network interface has 3 main settings which can be selected:
- DHCP
- Static
- IP-address
- Gateway IP-address
- DNS
- Alternate DNS
The Server Hostname is common to all interfaces and only needs to be set for one interface.
The current status of the selected ethernet interface is displayed:
 |
| Current configuration |
- IPv4 Address: Current IP-address of the interface. This may be different from the setting in the IP-address field, if the new setting has not been saved yet. If the port is not connected it will show as status Disconnected
- Hardware Address: The MAC-address of the interface