Difference between revisions of "SET CALL REQ MODE"
From Zenitel Wiki
| Line 18: | Line 18: | ||
|align=center|4||[[UINT1]]||colspan="3"|New call requester mode:<br\> 0 = off<br\>1 = on | |align=center|4||[[UINT1]]||colspan="3"|New call requester mode:<br\> 0 = off<br\>1 = on | ||
|- | |- | ||
| − | |align=center|5||[[UINT1]]<br\>||colspan="3"|Mail Priority 0 - 255<br\> [[ | + | |align=center|5||[[UINT1]]<br\>||colspan="3"|Mail Priority 0 - 255<br\> [[Mail priority]] |
|- | |- | ||
| − | |align=center|6||[[UINT1]]<br\>||colspan="2"|Mail Flags: [[ | + | |align=center|6||[[UINT1]]<br\>||colspan="2"|Mail Flags: [[Mail flags]] |
|- | |- | ||
|colspan="2"|Response:||colspan="3"|[[COMMAND_RESPONSE]] | |colspan="2"|Response:||colspan="3"|[[COMMAND_RESPONSE]] | ||
Revision as of 08:46, 16 December 2010
| SET_CALL_REQ_MODE | 0x006C | 108 | AMC 07.00 | |
|---|---|---|---|---|
| $SCRM L101 L102 U0 U1 | ||||
| Turn on/off message "your call is registered, please wait", then ring/flashing at a station. Note that the station leaves this mode if becomes busy for some reason (dialing, incoming conv.)<br\>"Call requester mode" is normally used to inform the user about a successful activation of call request. | ||||
| 1 | NET_OBJ_REF<br\>{ECL_STATION} | Station | ||
| 2 | NET_OBJ_REF<br\>{ECL_STATION} | Station that received the call request mail (i.e. sender of this command) | ||
| 3 | UINT1 | UserDefined Properties (UDP) of the station that received the call request mail. | ||
| 4 | UINT1 | New call requester mode:<br\> 0 = off<br\>1 = on | ||
| 5 | UINT1<br\> | Mail Priority 0 - 255<br\> Mail priority | ||
| 6 | UINT1<br\> | Mail Flags: Mail flags | ||
| Response: | COMMAND_RESPONSE | |||