Difference between revisions of "COMMAND RESPONSE"
From Zenitel Wiki
m |
|||
| Line 1: | Line 1: | ||
| + | {{A}} | ||
{| border="1" | {| border="1" | ||
|- | |- | ||
Revision as of 15:41, 16 January 2017
| COMMAND_RESPONSE | 0x0066 | 102 | AMC 07.00 | |
|---|---|---|---|---|
| General response message to messages introduced in AMC 07.00 or newer messages.
(COMMAND_RESPONSE is used rather than dedicated XXX_ACK and XXX_NAK messages ) | ||||
| 1 | UINT2 | The message_id that this message is a response to.
Example: 0x0065 if this message is a response to CANCEL_MAIL. | ||
| 2 | UINT1 | Command status, possible values are:
1 = Command performed successfully. 3 = Internal resource was busy, no queuing. 4 = Access not allowed. (OPC: no license) 5 = Target busy, command queued. 6 = Target HW failed/not present (OPC: overlapping registration of same OPC device from different nodes). | ||
| 3 | UINT4 | Command response options:
Additional information about the execution of the message. Interpretation of this field is dependent on the message id, see separate descriptions under each message having this message as response. | ||