Difference between revisions of "AMC-IP software upgrade (Black AMC-IP board)"
From Zenitel Wiki
Line 1: | Line 1: | ||
[[Image:AMC Black.PNG|thumb|250px|AMC-IP Processor Board (Black)]] | [[Image:AMC Black.PNG|thumb|250px|AMC-IP Processor Board (Black)]] | ||
This article describes how to upgrade the software on an black AMC-IP board, hardware revision 5 or later. | This article describes how to upgrade the software on an black AMC-IP board, hardware revision 5 or later. | ||
+ | |||
+ | This is the currently produced AMC-IP board, and replaced the red AMC-IP board (hardware revision 4) in 2009. | ||
Revision as of 09:56, 8 December 2015
This article describes how to upgrade the software on an black AMC-IP board, hardware revision 5 or later.
This is the currently produced AMC-IP board, and replaced the red AMC-IP board (hardware revision 4) in 2009.
Backup
Configuration data will be lost when doing the upgrade.
The customer data MUST be backed up by doing a GetAll operation from AlphaPro before the upgrade is performed.
Upgrading to AMC-IP software version 11.5.3.1
The software 11.5.3.1 is only supported on the black AMC IP boards (HW version 5 and higher). Hardware revision 4 or earlier (the red AMC-IP board) is not supported.
Upgrade procedure
Download the file bsp_31.00.3.2.apkg. This file contains the AMC-IP software version 11.5.3.1, as well as updated Linux version and security updates.
- Use an internet browser and log on to the AlphaCom Web interface (AlphaWeb) and select System Maintenance -> System Upgrade.
- Browse to the previously downloaded bsp file, and select Upload. The file will now be transferred from the PC to the AMC-IP board.
- When the upload is finished an Install button will appear. Press the Install button, the upgrade status is shown in the web browser.
- When the software installation is finished the system will restart with the new software.
- Restore the customer data by doing a SendAll operation from AlphaPro. Reset the exchange when the SendAll is finished.