Difference between revisions of "Group Call - Increased volume"
From Zenitel Wiki
Line 1: | Line 1: | ||
This article describes how to increase the volume of a group call announcement. The volume is set back to default value when the group call is ended. | This article describes how to increase the volume of a group call announcement. The volume is set back to default value when the group call is ended. | ||
+ | |||
+ | '''Note''': This event is CPU extensive. Maximum members in a group using this feature should not exceed approx. 50 stations. | ||
Minimum software is AMC version 11. | Minimum software is AMC version 11. |
Revision as of 16:22, 2 June 2015
This article describes how to increase the volume of a group call announcement. The volume is set back to default value when the group call is ended.
Note: This event is CPU extensive. Maximum members in a group using this feature should not exceed approx. 50 stations.
Minimum software is AMC version 11.
In the following example the volume will be set to level 6 when group call 86 is called from stations in UDP group 2. The volume is set to level 3 (default) when the group call is ended.
In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:
Event Owner: | Stations with UDP: Id: 2 |
Event type: | 08 - Conversation Outgoing |
Sub event: | 0 |
When change to: | ON or OFF |
When related to: | Directory Number, Id: 86 |
Action: |
IF %chg(1,0) tmp 0 "%gns(%2.phy,0)" LOOP IF %op(%tmp(0),=,0) STOP ENDIF $VOL N%tmp(0) U6 tmp 0 "%gns(%2.phy, %tmp(0))" ENDLOOP stop ENDIF tmp 0 "%gns(%2.phy,0)" LOOP IF %op(%tmp(0),=,0) STOP ENDIF $VOL N%tmp(0) U3 tmp 0 "%gns(%2.phy, %tmp(0))" ENDLOOP