Actions

Difference between revisions of "Voice Activity Detection (VAD)"

From Zenitel Wiki

(User interface)
(User interface)
Line 22: Line 22:
 
* '''Minimum amplitude (dBA):''' Choose the trigger amplitude
 
* '''Minimum amplitude (dBA):''' Choose the trigger amplitude
 
* '''Minimum duration of audio (ms):''' Choose for how long the sampled amplitude must be above the "Trigger ampltiude" before triggering the DAK key
 
* '''Minimum duration of audio (ms):''' Choose for how long the sampled amplitude must be above the "Trigger ampltiude" before triggering the DAK key
* '''DAK key to activate:''' Choose which DAK key to trigger
+
* '''DAK key to activate:''' Choose which DAK key to trigger. The station will simulate that this DAK key is pressed.
 
* '''Minimum time before reactivation (ms):''' Choose how long to wait before enabling VAD after triggering the DAK key
 
* '''Minimum time before reactivation (ms):''' Choose how long to wait before enabling VAD after triggering the DAK key
* '''Report DAK key off after (ms):''' With this parameter it is possible to delay sending DAK key off for some time
+
* '''Report DAK key off after (ms):''' This parameter sets the duration of the DAK key press.
  
 
== Notes on operation ==
 
== Notes on operation ==

Revision as of 15:43, 25 August 2017

AlphaCom icon 300px.png

Voice Activity Detection (VAD) or Sound Detection is a feature available for the IP Station range. Voice Activity Detection samples the peak amplitude detected at the microphone every 30 ms and converts it to dB. If the sampled amplitude is continously above a trigger amplitude for a set duration, then a DAK key is triggered.

The VAD feature is available when the station operates in AlphaCom mode.

User interface

The Voice Activity Detection configuration is done from the IP-station web interface at:

The following settings are possible to configure:

Voice Activity Detection configuration page in Inca stations


Sound Detection configuration page in Turbine stations


  • Sound Detection status: Enable or Disable the feature
    • In Turbine v. 4.7 there are three options:
      • Disable
      • Enable (Disable When Audio Out)
      • Enable Always)
  • Minimum amplitude (dBA): Choose the trigger amplitude
  • Minimum duration of audio (ms): Choose for how long the sampled amplitude must be above the "Trigger ampltiude" before triggering the DAK key
  • DAK key to activate: Choose which DAK key to trigger. The station will simulate that this DAK key is pressed.
  • Minimum time before reactivation (ms): Choose how long to wait before enabling VAD after triggering the DAK key
  • Report DAK key off after (ms): This parameter sets the duration of the DAK key press.

Notes on operation

  • The sound pressure SPL is dropping by 6 dB (four times) for every doubling of the distance from the microphone.
  • The audio detection is before the noise reduction circuit, so in case Noise Reduction is activated, noise will always cause the detector to trigger.
  • The VAD is working only when the station is in idle. It will not work if the Station is for example in conversation or in conference.
  • The VAD feature is only available when the station is used in AlphaCom mode. The feature is not available in Pulse or SIP mode.

Software requirement

  • INCA Station software 01.09.3.0 or later.
  • Turbine: available in all versions

Related articles