Difference between revisions of "1-3b. IP Stations – Substations (solution)"
From Zenitel Wiki
(→Configure the IP Substation) |
(→Configure the AlphaCom XE) |
||
Line 23: | Line 23: | ||
===Configure the AlphaCom XE=== | ===Configure the AlphaCom XE=== | ||
− | *In AlphaPro go to '''Users & Stations''', and select physical number | + | *In AlphaPro go to '''Users & Stations''', and select physical number 39; 139 Station 39 |
*Use the section on the right and change the configuration as follows: | *Use the section on the right and change the configuration as follows: | ||
− | [[File:1- | + | [[File:1-3b solution3.PNG|thumb|left|400px|AlphaPro: Users & Stations window]] |
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
Revision as of 17:03, 22 March 2011
Configure the IP Substation
- Perform a "Factory Default" setting on the IP Substation
- Press the call button
- While the button is pressed, connect the IP Substation to the PoE switch
- Wait until the call LED of the station starts to flash
- Release the call button for exactly two flashes
- Push the button briefly
- Assign the PC an IP address in the range 169.254.x.x
- Connect the PC to the network switch
- On the PC start a web browser, and enter the IP station address 169.254.1.100 in the address field
- Log in with Username: admin, password: alphaadmin
- Select CCoIP Configuration, and enter the following parameters:
- Connect the IP substation and the AlphaCom XE (Eth1) to the same network switch
Configure the AlphaCom XE
- In AlphaPro go to Users & Stations, and select physical number 39; 139 Station 39
- Use the section on the right and change the configuration as follows:
- Send the changes to the AlphaCom XE