INCA Station Restore Factory Defaults: Difference between revisions

Revision as of 16:53, 17 March 2017

The unit can be set to use either Static IP or DHCP. This procedure is applicable for the stations:

IP Master Station Kit - 1008093000 - A push button must be connected between pin 1 and pin 4 on connector P4.
The IP Substation Kit - 1008090200 - A push button must be connected between pin 1 and pin 4 on connector P4.

Kits require a push button to be connected between pins 1 and 4

Procedure:

While pressing the call button, power up the station and keep the button pressed.
Release the button after exactly 2 flashes of the LED.
Let the LED flash for exactly 2 more times (Static IP) or exactly 4 more times (DHCP), then press the button again.
Keep the button pressed until the LED flashes fast 2 times (Static IP) or flashes fast 4 times (DHCP) indicating a successful reset.
Release the button and the station will restart with the factory default settings.

Factory default values:

* Software 01.06 and earlier: Username/password isADMIN/alphacom

@@ Line 5: / Line 5: @@
 [[File:Load Defaults without Display - 1.PNG|right|200px]]
 [[File:Load Defaults without Display - 2.PNG|right|200px]]
-This procedure is also applicable for these kits:
+* [[IP Master Station Kit - 1008093000]] - A push button must be connected between pin 1 and pin 4 on connector P4.
-* [[IP Master Station Kit - 1008093000]]
+* The [[IP Substation Kit - 1008090200]] - A push button must be connected between pin 1 and pin 4 on connector P4.
-* The [[IP Substation Kit - 1008090200]]
-This requires that a push button is connected between pin 1 and pin 4 on connector P4.
 [[File:Load Defaults without KEY.PNG|left|thumb|300px|Kits require a push button to be connected between pins 1 and 4]]
 <br style="clear:both;" />