Difference between revisions of "Flowire"
From Zenitel Wiki
| Line 7: | Line 7: | ||
* FCDC2 (1008080210) - without [[PoE]] - [https://www.zenitel.com/printpdf/product/fcdc2 datasheet] | * FCDC2 (1008080210) - without [[PoE]] - [https://www.zenitel.com/printpdf/product/fcdc2 datasheet] | ||
| + | |||
| + | == Factory defaults == | ||
| + | * Static IP address : 169.254.1.10 | ||
| + | * DHCP enabled. If obtain an dynamic address, it comes in addition to the static address. | ||
| + | * NMK Password: HomePlugAV0123 | ||
| + | |||
== Reset to Factory defaults == | == Reset to Factory defaults == | ||
Flowire can be reset to Factory defaults by pressing the button for 15 seconds. The recessed button is located next to the Ethernet connector. | Flowire can be reset to Factory defaults by pressing the button for 15 seconds. The recessed button is located next to the Ethernet connector. | ||
[[Category: Flowire]] | [[Category: Flowire]] | ||
Revision as of 13:43, 1 March 2017
Flowire is based on the HomePlug AV power line communications specification, only using 24 - 48 V DC as the medium. It is a network bridge between Ethernet and a PLC link.
There are two variants
Factory defaults
- Static IP address : 169.254.1.10
- DHCP enabled. If obtain an dynamic address, it comes in addition to the static address.
- NMK Password: HomePlugAV0123
Reset to Factory defaults
Flowire can be reset to Factory defaults by pressing the button for 15 seconds. The recessed button is located next to the Ethernet connector.