Actions

Difference between revisions of "Flowire"

From Zenitel Wiki

Line 6: Line 6:
 
* [[FCDC-1]] (1008080110 ) - Forwards power to the spare pairs of the Ethernet port  
 
* [[FCDC-1]] (1008080110 ) - Forwards power to the spare pairs of the Ethernet port  
 
* [[FCDC-2]] (1008080210) - Does not forward power to the Ethernet port
 
* [[FCDC-2]] (1008080210) - Does not forward power to the Ethernet port
{{note|The FCDC-1 forwards the power from the Power Supply Unit to the Ethernet port. It is '''not''' using [[PoE]] (Power over Ethernet) technology}}
+
{{note|The FCDC-1 is directly forwarding the power from the Power Supply Unit to the Ethernet port. It is '''not''' using [[PoE]] (Power over Ethernet) technology}}
 
== Factory defaults ==
 
== Factory defaults ==
 
* Static IP address : '''169.254.1.10'''
 
* Static IP address : '''169.254.1.10'''

Revision as of 12:42, 31 May 2018

APS.png
TCIS-1

Flowire is based on the HomePlug AV power line communications specification, only using 24 - 48 V DC as the medium. It is a network bridge between Ethernet and a PLC link.

There are two variants:

  • FCDC-1 (1008080110 ) - Forwards power to the spare pairs of the Ethernet port
  • FCDC-2 (1008080210) - Does not forward power to the Ethernet port
Note icon The FCDC-1 is directly forwarding the power from the Power Supply Unit to the Ethernet port. It is not using PoE (Power over Ethernet) technology


Factory defaults

  • Static IP address : 169.254.1.10
  • DHCP enabled. If obtain an dynamic address, it comes in addition to the static address.
  • NMK Password: HomePlugAV0123

MAC address range: 00:13:CB:0A:00:00 -> 00:13:CB:0A:80:00

Reset to Factory defaults

Flowire can be reset to Factory defaults by pressing the button for 15 seconds. The recessed button is located next to the Ethernet connector.