Tamper switch: Difference between revisions
From Zenitel Wiki
ZenitelAus (talk | contribs) No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
{{AEIPS}} | {{AEIPS}} | ||
The | The [[IP Vandal Resistant Substation TKIE|IP Vandal Resistant Substation with TKIE]] has the possibility to be fitted with a tamper switch. Making it possible to raise an alarm if the station is dismounted from the backbox. | ||
[[file:1008091010.png|200px|thumb|Tamper Switch<br>(1008091010)|alt=]] | [[file:1008091010.png|200px|thumb|Tamper Switch<br>(1008091010)|alt=]] | ||
Revision as of 07:42, 16 September 2021
The IP Vandal Resistant Substation with TKIE has the possibility to be fitted with a tamper switch. Making it possible to raise an alarm if the station is dismounted from the backbox.
Configuration
In AlphaPro, create this event for the Tamper Switch:
The IP Substation must have I/O 3 defined as an input, which is the default setting.
Mounting
Mounting instruction on Tamper Switch for IP Vandal Resistant Substation TKIE
Step 1: Remove the two nylon nuts shown below
Step 2: Attach the supplied spacers
Step 3: Mount the tamper switch board
Step 4: Move the button GND wire from the the TKIE board to the tamper switch board
Step 5: Use the supplied wires to connect GND and Input 3 as shown below
