STATUS REPORT

STATUS_REPORT		0x0072	114	AMC 07.30
Report equipment Presence and Error/OK status for Subscriber Lines, Audio Links, Devices, Boards, etc. Intended for remote logging and external monitoring systems. As the message is very general, the message definition will be followed by a detailed example of how the different parameters are used for each “entity” type. Unused parameters/flags are always set to 0. AlphaCom can be programmed to forward STATUS_REPORT messages to two addresses. See Exchange_&_System_(AlphaPro)#Logs_and_Errors, "System Log and Error Reports to".
1	NET_OBJ_REF {ECL_STATION, ECL_AUDIO_RING, ECL_AUDIO_LINK, ECL_BOARD, ECL_DEVICE, ECL_NODE}	Entity Reference to the Station / Inter­Exchange Link / ICC Audio Ring / Board / Device / Exchange the status message is for. The entity number is a logical number, e.g. station from 1 to 552.
2	NET_OBJ_REF {NRF_PHYS_ADDR}	Physical address for the entity defined in parameter 1. This is a hardware module/board/port type of information.
3	BITMAP[1..8]	(Error) State Flags. Bit 1 = Interface present: Bit 2 = Interface test: Bit 4 = Signaling test: Bit 6 = Audio test: Bit 7 = Device dependent test	Board present in exchange Board reports entity missing/down Last signaling test failed Last audio (tone) test failed
4	BITMAP[1..8]	(State) Change Flags. Each bit is set if the corresponding state flag bit was changed from the previous report and cleared if it was unchanged.
5	BITMAP[1..8]	Reporting Flags. Bit 8 = VERBOSE. The report is from a manually/externally started test, where the user wants a complete report.
6	UINT1	Extra (Error) Status Information 1.
7	UINT1	Extra (Error) Status Information 2.
8	NET_OBJ_REF (optional)	Entity Information field 1. .
STATUS_REPORT for Stations:
1	NET_OBJ_REF	Station from 1 to 552. The Sub Class field specifies the type of station interface (TouchLine, Telephone). Status info. can have different meaning for each Sub Class.
2	NET_OBJ_REF	Physical address: Module/board/port. The (Implicit Type) Resource Address format is used
3	BITMAP[1..8]	(Error) State Flags. Bit 1 = Interface present: Bit 2 = Interface test: Bit 6 = Audio test: Bit 7 = Device dep. test:	---What is reported for Stations:--- ASLT/ATLB board missing ASLT/ATLB wire monitoring Tone Test Handset Off-Hook timeout	(no active report) (only failures) (only changes) (only failures)
5	BITMAP[1..8]	Reporting Flags. Bit 8 = VERBOSE.	Set by Tone Test started from station.
6	UINT1	Status information 1.	Bits describing ab- and cd- wire errors
7	UINT1	Status information 2.	TouchLine: Tone test signal/noise value. Telephone: Wire monitor current.
8	NET_OBJ_REF	Entity Information field 1	Directory Number.

Back to AlphaNet message list