TKIV+ Dimensions & Mounting Instructions: Difference between revisions
From Zenitel Wiki
No edit summary |
|||
| Line 1: | Line 1: | ||
{{AEIS}} | {{AEIS}} | ||
=Dimensions CPU module= | =Dimensions CPU module= | ||
Revision as of 09:38, 10 August 2022
Dimensions CPU module
Dimensions Camera module
TKIV+ Camera Module Mounting instruction
The installation should be performed in an ESD Safe working environment using a flat-head screwdriver.
The flat cable comprises one side that has a blue tape and one side that has the contact.
|
Make sure that the distance between the CPU module and the camera unit does not exceed 50 mm so as not to strain the cable. |
Connecting the Flat Cable to the CPU Module
1. Use a flat-head screwdriver to release the snap locks on both short sides of the CPU module and gently pry the cover off.
 |
2. Open the FFC contact on the CPU board by carefully lifting the lever at both ends.
 |
3. Insert the cable into the contact with the blue tape side facing up and the contact side facing down.
 |
4. Close the contact by pressing down the lever at both ends simultaneously.
|
Connecting the Flat Cable to the Camera unit
- Open the FFC contact on the camera unit by carefully lifting the lever at both ends.
- Thread the flat cable through the strain relief on the camera unit.
- Insert the cable into the contact with the contact side facing up and the blue tape side facing down.
- Close the contact by pressing down the lever at both ends simultaneously.