Tamper switch: Difference between revisions

Revision as of 13:42, 1 December 2022

The IP Vandal Resistant Substation with TKIE has the possibility to be fitted with a tamper switch. Making it possible to raise an alarm if the station is dismounted from the backbox.

Tamper Switch
(1008091010)

Configuration

For a single station

In AlphaPro, create this event for the Tamper Switch, setting the cell station as the event owner:

Event handler configuration

Action commands:

$STM L110 L101 U100 'TAMPER CELL 10'

For all stations

Verify that I/O 3 is set as an input

The IP Substation must have I/O number 3 defined as an input (default).

Advanced AlphaCom -> I/O Settings

Mounting

Mounting instruction on Tamper Switch for IP Vandal Resistant Substation TKIE

Step 1: Remove the two nylon nuts shown below

Step 2: Attach the supplied spacers

Step 3: Mount the tamper switch board

Step 4: Move the button GND wire from the the TKIE board to the tamper switch board

Step 5: Use the supplied wires to connect GND and Input 3 as shown below

@@ Line 4: / Line 4: @@
 ==Configuration==
-=== For a single station ==
+=== For a single station ===
-In [[AlphaPro]], create this event for the Tamper Switch:
+In [[AlphaPro]], create this event for the Tamper Switch, setting the cell station as the event owner:
 [[file:TamperSwitchEvent.png|500px|thumb|left|Event handler configuration]]
 <br style="clear:both;" />
@@ Line 11: / Line 11: @@
 {{code2|$STM L110 L101 U100 'TAMPER CELL 10'}}
+=== For all stations ===
+=== Verify that I/O 3 is set as an input ===
 The IP Substation must have I/O number 3 defined as an input (default).
 [[file:TamperSwitchWeb.png|500px|thumb|left|Advanced AlphaCom -> I/O Settings]]
@@ Line 17: / Line 20: @@
-=== For all stations ==
 ==Mounting==