VR3G-1(P) Mounting and Dimensions

VR3G-1 and VR3G-1P stations

Installation

VR3G-1 can be powered by PoE. This is done by connecting an Ethernet cable to the LAN port of the station and a PoE switch.

If PoE is used, the station must be installed using a shielded Ethernet cable with grounding at the switch end

If the switch does not support PoE, a 24VDC power supply can be connected to the stations Power Input.

If an external power supply is being used, please make sure the power supply matches the station

Mounting

Mounting considerations

Check the specification of the product for the installation environment.

To achieve the vandal resistance the station is designed for, the intercoms must be flush mounted.

To ensure the IP66 rating and that nothing can penetrate behind the edge of the intercom, it must be mounted on a surface that is completely planar.

Flush mounting

When flush mounting vandal resistant station, use the 3 Gang Flush Mount back box.

3 Gang Backbox

• Ready one of the pre-punched holes in the backbox for power and network wiring.
• Have the necessary cables ready before starting the mounting procedure

Mounting the VR3G-1(P)

1. Insert and secure the 3 Gang Flush Mount back box into designated slot in the wall. Make sure that the box is squarely mounted and the front surface flush with the wall surface.
2. Plug the Ethernet cable into LAN port on the station. If the switch does not support PoE, a 24VDC Power Supply can be connected to the stations Power Input.
3. Mount the Vandal Resistant Station onto the back box with the 6-32 UNC X ¾ fasteners provided. Apply 1.5 Nm / 1.1 lb-ft torque.

Make sure the Tamper Switch is properly connected to the back end of the back box.

Re-tighten the screws after mounting, as the gasket behind the front plate will get compressed.

Dimensions

• Dimensions (HxWxD): 160x114x60mm
• Dimensions after flush mount: 160x114x5mm

VR3G-1 Dimensions

• Return to Vandal Resistant intercom - VR3G-1
• Return to Vandal Resistant intercom - VR3G-1P