SET CALL REQ MODE: Difference between revisions
From Zenitel Wiki
No edit summary |
No edit summary |
||
| Line 22: | Line 22: | ||
|} | |} | ||
[[Category: ACDP messages]] | |||
[[AlphaNet_Data_Protocol#Station_Features_and_Status|Back to AlphaNet message list]] | [[AlphaNet_Data_Protocol#Station_Features_and_Status|Back to AlphaNet message list]] | ||
Revision as of 21:32, 17 December 2007
| SET_CALL_REQ_MODE | 0x006C | 108 | AMC 07.00 | |
|---|---|---|---|---|
| $SCRM L101 L102 U0 U1 | ||||
| Turn on/off message "your call is registered, please wait", then ring/flashing at a station. Note that the station leaves this mode if becomes busy for some reason (dialing, incoming conv.)<br\>"Call requester mode" is normally used to inform the user about a successful activation of call request. | ||||
| 1 | NET_OBJ_REF<br\>{ECL_STATION} | Station | ||
| 2 | NET_OBJ_REF<br\>{ECL_STATION} | Station that received the call request mail (i.e. sender of this command) | ||
| 3 | UINT1 | UserDefined Properties (UDP) of the station that received the call request mail. | ||
| 4 | UINT1 | New call requester mode:<br\> 0 = off<br\>1 = on | ||
| Response: | COMMAND_RESPONSE | |||