Difference between revisions of "RCO - Set Remote Control Output"
From Zenitel Wiki
(→Example) |
(→Example) |
||
Line 7: | Line 7: | ||
== Example == | == Example == | ||
− | RCO 10 - The | + | RCO 10 - The RCO number 10 will follow the event ON and OFF |
− | RCO 10 ON – Turns ON the | + | RCO 10 ON – Turns ON the RCO number 10 |
− | RCO 10 ON 25 – | + | RCO 10 ON 25 – Pulse RCO number 10 for 2.5 seconds |
[[Category:Event Handler]] | [[Category:Event Handler]] | ||
[[Category:Built-In Action Commands]] | [[Category:Built-In Action Commands]] |
Revision as of 12:02, 24 September 2008
The RCO command is used to control relays.
Syntax
RCO <RCO.logical.no> <ON/OFF> <Pulse time>
Example
RCO 10 - The RCO number 10 will follow the event ON and OFF RCO 10 ON – Turns ON the RCO number 10 RCO 10 ON 25 – Pulse RCO number 10 for 2.5 seconds