Difference between revisions of "Group Call - Increased volume"
From Zenitel Wiki
Line 11: | Line 11: | ||
|- | |- | ||
|width="150pt"|'''Event Owner''': | |width="150pt"|'''Event Owner''': | ||
− | |width="400pt"|Stations with UDP: Id: | + | |width="400pt"|Stations with UDP: Id: 2 |
|- | |- | ||
|'''Event type''': || [[Conversation Outgoing (Event Type)|08 - Conversation Outgoing]] | |'''Event type''': || [[Conversation Outgoing (Event Type)|08 - Conversation Outgoing]] |
Revision as of 16:18, 2 June 2015
This article describes how to increase the volume of a group call announcement. The volume is set back to default value when the group call is ended.
Minimum software is AMC version 11.
In the following example the volume will be set to level 6 when group call 86 is called from stations in UDP group 2. The volume is set to level 3 (default) when the group call is ended.
In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:
Event Owner: | Stations with UDP: Id: 2 |
Event type: | 08 - Conversation Outgoing |
Sub event: | 0 |
When change to: | ON or OFF |
When related to: | Directory Number, Id: 86 |
Action: |
IF %chg(1,0) tmp 0 "%gns(%2.phy,0)" LOOP IF %op(%tmp(0),=,0) STOP ENDIF $VOL N%tmp(0) U6 tmp 0 "%gns(%2.phy, %tmp(0))" ENDLOOP stop ENDIF tmp 0 "%gns(%2.phy,0)" LOOP IF %op(%tmp(0),=,0) STOP ENDIF $VOL N%tmp(0) U3 tmp 0 "%gns(%2.phy, %tmp(0))" ENDLOOP