IP Flush Master DAK-48 Module

DAK-48 Unit

• Item number: 1008010100

Note! The license 1009648001 is required to extend the IP Flush Master with the optional IP DAK-48 Unit.

Highlights

• Extends IP Flush Master Station with 48 programmable DAK keys (direct access keys)
• Ideal for control room applications
• Visual indications with two LEDs (green/red) per DAK key
• All keys have backlight (adjustable)
• Easy labeling of keys

Software requirements

• IP Flush Master: Version 01.09.3.0 or later
• AMC-IP: Version 10.60.3.0 or later

Installation

DAK-48 Expansion module

The IP DAK-48 unit expands the IP Flush Master station with an additional 48 Direct Access Keys. Up to two DAK-48 units can be connected to one station.

To interconnect the DAK-48 unit to the main unit, use the cable which is coming with the DAK-48 unit. The DAK-48 unit receive its power and data via this cable.

WARNING: A standard patch cable (1:1) must not be used. It might damage the unit!

Installing the IP DAK-48 Unit:

• Power off the IP Flush Master station by disconnecting the ethernet cable in the LAN port
• Plug one end of the cable coming with the DAK-48 unit into the RJ45 port on the right hand side of the IP Flush Master station (when the station is viewed from the front).
• Plug the other end of the cable into the left RJ45 port on the DAK-48 unit (when the unit is viewed from the front).
• Power up the IP Flush Master station by connecting the ethernet cable to the LAN port

Installing the IP DAK-48 Unit

To add another DAK unit, plug one end of an RJ45-RJ45 cable into the RJ45 port of 
the installed unit and plug the other end into the RJ45 port of the new unit.

Related article

• IP Flush Master - 1008031000
• Back box flush mount - 1008098700
• DAK expansion license

Related products

• Label Paper for IP DAK-48 Unit - 1008010101 (20 sheets)