| SET_CALL_REQ_MODE
|
0x006C
|
108
|
AMC 07.00
|
| $SCRM L101 L102 U0 U1
|
| Turn on/off message "your call is registered, please wait", then ring/flashing at a station. Note that the station leaves this mode if becomes busy for some reason (dialing, incoming conv.)<br\>"Call requester mode" is normally used to inform the user about a successful activation of call request.
|
| 1 |
NET_OBJ_REF<br\>{ECL_STATION} |
Station
|
| 2 |
NET_OBJ_REF<br\>{ECL_STATION} |
Station that received the call request mail (i.e. sender of this command)
|
| 3 |
UINT1 |
UserDefined Properties (UDP) of the station that received the call request mail.
|
| 4 |
UINT1 |
New call requester mode:<br\> 0 = off<br\>1 = on
|
| Response: |
COMMAND_RESPONSE
|
Back to AlphaNet message list
