ATLB-12 - AlphaCom Telephone Line Board
From Zenitel Wiki
Contents
Features
- High capacity line card for analogue telephones supporting 12 subscribers lines
- Supports all ACM telephone features
- Supports hotline calling and DTMF dialing
- Each board supports 6 programmable remote outputs
- Includes voice switching circuits for two load-speaking conversations
- Board hot plug-in
Description
The ATLB-12 card is a high capacity analogue telephone line card supporting 12 subscriber lines. The subscribers have access to all STENTOFON AlphaCom telephone features. A hot-line function is available for connection of telephones without dial buttons. When the handset is lifted, a preprogrammed number is dialed. This can be a call to another subscriber or activation of a function in the exchange. The board provides 6 configurable remote control outputs for interfacing of external equipment such as strobe lights, PA control signals and more. The card can be inserted in position 1-6 in the AlphaCom E7 exchange, and position 1-23 in the AlphaCom E20 and E26 exchanges. In AlphaCom E20 and E26 exchanges, the board can be plugged in or out while the exchange is running using the board hot-swap function.
Connection Boards
The standard connection board provides connection for 12 analogue telephones and 6 RCO outputs.
The ATLB-12 provides connection for 6 analogue telephones and 6 RCO outputs. In addition the board provides protection against heavy transients and a ring voltage generator. This board is used when the subscriber cabling may be exposed to heavy transients and should always be used if there are outdoor cables. The ring voltage generator is needed when there are several phones in parallel on the same line, or the lines are very long.
AlphaCom E20/E26
Telephones and control outputs are connected to a connection board mounted on the exchange connection field.
Telephone connection board with transient protection (100 9930 202) and subscriber connection cable with filter board (100 9501 031) must be purchased separately.
AlphaCom E7
All telephones are connected by means of pluggable screw terminals on the exchange back-plane.
Note: When the ATLB-12 board is used in AlphaCom E7 only four RCO's are available.
Specifications
Order Number: | 5, 15, 24, 32 V DC |
---|---|
Dimensions (WxHxD) <br\><br\> | 10mm x 230mm x 263mm <br\> 0.39"x 8.97"x 10.26" <br\> Double Extended Europe Format |
S/N ratio (conversation): 45 dB | |
Input impedance: | 600 ohm |
Frequency range conversation: | 300 - 3,400 Hz |
Crosstalk at 1 kHz: | <- 75 dB |
Capacity for each ATLB board: <br\> Duplex-controlled conversations: | 6 subscrivers <br\> 1 voice-switched conv. per board |
Remote control outputs: | 5 V 2.2 kOhm |
Cable type: <br\> Max cable length to station: <br\> | 1-pair twisted cable per station <br\> 3km (0.5 mm2 - 24AWG) <br\> 4km (0.6mm2 - 22AWG) |
Distortion: | <2% |
Indicator: | LED (red/green/amber) |