1-3b. IP Stations – Substations (solution)

System configuration

Configure the IP Substation

• Perform a "Factory Default" setting on the IP Substation
  • Press the call button
  • While the button is pressed, connect the IP Substation to the PoE switch
  • Wait until the call LED of the station starts to flash
  • Release the call button for exactly two flashes
  • Push the button briefly
• Assign the PC an IP address in the range 169.254.x.x
• Connect the PC to the network switch

File:1-3b solution1.png

Accessing the IP Substations web page

• When prompted, Save the changes. When asked for "Restart now" you can select "No".
• Step to the menu selection AlphaCom IP and enter the following parameters:

Off-line menu: AlphaCom settings

• When prompted, Save the changes.
• Step to the menu selection Restart and activate a restart of the station

Configure the AlphaCom XE

• In AlphaPro go to Users & Stations, and select physical number 37; 137 Station 37
• Use the section on the right and change the configuration as follows:

AlphaPro: Users & Stations window

• In AlphaPro go to Users & Stations, and select physical number 38; 138 Station 38
• Use the section on the right and change the configuration as follows:

AlphaPro: Users & Stations window

• Send the changes to the AlphaCom XE

---

Related articles

• 1-3b. IP Stations – Substations (practice)