INCA Station Restore Factory Defaults

This procedure is applicable for the stations:

• IP Substations - 1008041100/1008051000
• IP Video Door Stations - 1401110100/1401110200
• IP Master Station Kit - 1008093000 - A push button must be connected between pin 1 and pin 4 on connector P4.
• The IP Substation Kit - 1008090200 - A push button must be connected between pin 1 and pin 4 on connector P4.

Kits require a push button to be connected between pins 1 and 4

Procedure:
When loading factory defalt settings, the unit can be set to use either Static IP or DHCP.

1. While pressing the call button, power up the station and keep the button pressed.
2. Release the button after exactly 2 flashes of the LED.
3. Let the LED flash for exactly 2 more times (Static IP) or exactly 4 more times (DHCP), then press the button again.
4. Keep the button pressed until the LED flashes fast 2 times (Static IP) or flashes fast 4 times (DHCP) indicating a successful reset.
5. Release the button and the station will restart with the factory default settings.

Factory default values:

• Station Mode: Pulse
• Station IP address: 169.254.1.100 (Static) or DHCP
• Username: admin
• Password: alphaadmin

Software 01.06 and earlier: Username/password is ADMIN/alphacom