Advanced Output Handler (Pulse)

Introduction

With the introduction of Advanced Output Handler in Turbine SW version 4.11, it is now possible to better customize the relay/GPO handling to your preferences.

To enable the Advanced Output Handler, check the Use Advanced Output Handler checkbox in the Relay/Output settings page

Advanced Output Handler

Event Triggers

Output actions set by events have a priority/queue so that multiple actions on the same output is possible, but only one action can be done at a time.

The action will stay until it is cleared when the event ends and some other action has priority.

The priority order is: Active/Any Call > Group Call > Tone Test Failed > Registration Failed > Idle.

For example if the output is configured to be slow fash during call, fast flash during registration failed and off during idle. If we then have an ongoing call and registration fails, the output will be slow flashing untill the call has ended. After the call has ended, the output will be fast flashing untill the station is registered again, which makes idle action active (the relay should then be off).

If the output is set by DTMF it will stay set until some other event makes the output change state.

Event triggers

Possible Event Triggers are

DTMF:

Will trigger an event on received DTMF. The action will stay on until next event happens.

Active Call

The station may in some situations have multiple calls, the active call is the call which has media/tone handling.

Can be filtered so it will only trigger event on certain conditions.

State: Ringing, Queued, In Call, On Hold
Directory Number: Can either directory number or a range for example 100-199
Direction: Incoming, Outgoing or Incoming/Outgoing

If the state In Call is selected, the output will stay set until the call has ended.

Any Call

May match any call. Can for example be used to indicate that a call from a specific station 100 is calling.

Can filter so it only triggers the event on

State: Ringing, Queued, In Call, On Hold
Directory Number: Can either directory number or a range for example 100-199
Direction: Incoming, Outgoing or Incoming/Outgoing

If the state In Call is selected, the output will stay set until the call has ended.

Group Call

Event is triggered if the group call is active.

Tone Test Failed

Event is triggered if a tone test has failed. The output action will be cleared on tone test sucess.

Registration Failed

Event is triggered if registration failed. The output action will be cleared on registration success.

Idle

Event is triggered when station goes back to Idle.

Event Actions

Action can be either to control Relay or Output, and multiple IO's can be controlled in the same Event.

States can be same as in basic relay handling: steady off, steady on, slow flash, fast flash and timed steady on.

Event action operation

Example

Trigger Relay during call to specific number

In this example the Relay will only be triggered if the station is in or attempting a call to the number 911.

Relay during call - example