Actions

IP Flush Master Gooseneck

From Zenitel Wiki

Revision as of 09:47, 11 October 2021 by Roarl (talk | contribs)
AEIPS.png
Gooseneck Microphone. item no 1008097500

This microphone is for

To install the Gooseneck Microphone:

  • Remove the cover plug from the opening for the microphone on the front panel.
  • Thread the microphone cable through the opening, the lock washer and nut.
  • Tighten the nut on the microphone’s threaded stud.
  • Insert the microphone’s IDC socket into the upper two pins of the 3-pin header (J7) located at the lower left side of the station. The signal wire (white) should be on the top pin while the ground wire (green) should be on the bottom pin.
  • Slide the S1 switch (bottom back of station) to EXT to activate the external microphone function.

For board connectors, see:

IP Master Gooseneck Microphone Installation.PNG
Installing the Gooseneck Microphone


Gooseneck microphone connection
Gooseneck microphone connection, detailed


Related articles