Actions

VR3G-1(P) Mounting and Dimensions

From Zenitel Wiki

Revision as of 14:43, 8 September 2023 by Asle (talk | contribs) (→‎Dimensions)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
VR3G-1 and VR3G-1P stations


Installation

VR3G-1 can be powered by PoE. This is done by connecting an Ethernet cable to the LAN port of the station and a PoE switch.

Note icon If PoE is used, the station must be installed using a shielded Ethernet cable with grounding at the switch end


If the switch does not support PoE, a 24VDC power supply can be connected to the stations Power Input.

Note icon If an external power supply is being used, please make sure the power supply matches the station


Mounting

Mounting considerations

Check the specification of the product for the installation environment.

Note icon To achieve the vandal resistance the station is designed for, the intercoms must be flush mounted.


Note icon To ensure the IP66 rating and that nothing can penetrate behind the edge of the intercom, it must be mounted on a surface that is completely planar.



Flush mounting

When flush mounting vandal resistant station, use the 3 Gang Flush Mount back box.

3 Gang Backbox


  • Ready one of the pre-punched holes in the backbox for power and network wiring.
  • Have the necessary cables ready before starting the mounting procedure
Mounting the VR3G-1(P)


  1. Insert and secure the 3 Gang Flush Mount back box into designated slot in the wall. Make sure that the box is squarely mounted and the front surface flush with the wall surface.
  2. Plug the Ethernet cable into LAN port on the station. If the switch does not support PoE, a 24VDC Power Supply can be connected to the stations Power Input.
  3. Mount the Vandal Resistant Station onto the back box with the 6-32 UNC X ¾ fasteners provided. Apply 1.5 Nm / 1.1 lb-ft torque.
Note icon Make sure the Tamper Switch is properly connected to the back end of the back box.


Note icon Re-tighten the screws after mounting, as the gasket behind the front plate will get compressed.


Dimensions

VR3G-1

  • Dimensions (HxWxD): 160x114x60mm
  • Dimensions after flush mount: 160x114x5mm
VR3G-1 Dimensions


VR3G-1P

  • Dimensions (HxWxD): 160x114x60mm
  • Dimensions after flush mount: 160x114x4mm
VR3G-1P Dimensions



Retrieved from "https://wiki.zenitel.com/w/index.php?title=VR3G-1(P)_Mounting_and_Dimensions&oldid=233765"