SET CALL REQ MODE
From Zenitel Wiki
Revision as of 12:48, 14 June 2007 by 10.5.101.115 (talk)
SET_CALL_REQ_MODE | 0x006C | 108 | AMC 07.00 | |
---|---|---|---|---|
$SCRM L101 L102 U0 U1 | ||||
Turn on/off message "your call is registered, please wait", then ring/flashing at a station. Note that the station leaves this mode if becomes busy for some reason (dialing, incoming conv.)<br\>"Call requester mode" is normally used to inform the user about a successful activation of call request. | ||||
1 | NET_OBJ_REF<br\>{ECL_STATION} | Station | ||
2 | NET_OBJ_REF<br\>{ECL_STATION} | Station that received the call request mail (i.e. sender of this command) | ||
3 | UINT1 | UserDefined Properties (UDP) of the station that received the call request mail. | ||
4 | UINT1 | New call requester mode:<br\> 0 = off<br\>1 = on | ||
Response: | COMMAND_RESPONSE |