Actions

CP-Cam Factory Reset

From Zenitel Wiki

Revision as of 14:10, 5 February 2018 by Wikiadmin (talk | contribs) (1 revision imported)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

This should be carried out only by experienced technicians. The customer is liable for damages caused by improper opening of the housing.

If the entered IP address is unknown, it is possible to reset the address to 10.10.10.10 using the DIP switch. To proceed, the unit must be opened. 

Note: A change of the IP address is made via the web interface of the CP-CAM.

The procedure is as follows:

  1. Power off the station
  2. Open the CP-CAM so the two DIP switches are accessible ( see picture ).
  3. Note the switch position and then turn both switches to "OFF".
  4. Power On the station
  5. Connect PC with the IP number range 10.10.10.xxx and log in.
  6. Turn switch positions back to original positions.
  7. Set the desired IP address in the web interface. Press "Save Changes"
  8. Reboot station
  9. Close housing properly.
CP-CAM.PNG


Retrieved from "https://wiki.zenitel.com/w/index.php?title=CP-Cam_Factory_Reset&oldid=3213"