IP Substation - Amplified calling
From Zenitel Wiki
This article describes how to connect an external amplifier to the line output of the IP substation.
Contents
Power Amplifier 1000614100
Amplifier constanly on
The power amplifier is controlled through input 1 and 2. By strapping one can make the amplifier constantly on:
- Strap point 2 and 3
- Strap point 1 and 7
No programming is required.
Note: When the amplifier is constanly on some humming might be heard in the speaker in idle.
Amplifier controlled by relay
The amplifier can be switched on and off by the relay in the IP substation. The relay is controlled by the RCO command in the Event Handler.
How to configure the relay operation:
- In Exchange & System -> RCO, map a free RCO to the relay of the station.
- In Users & Stations select the IP station in the list box, and press the button 'Events'. 'Insert' a new event with the following attributes:
| Event Owner: | The IP station |
| Event type: | 1 - Audio |
| Subevent: | 126 (Press 'Details' to select which types of audio. 126 means all types of audio) |
| When change to: | ON or OFF |
| When related to: | (not used) |
| Action: | RCO 10 |
RCO 10 is used as an example. Use the RCO number you have assigned to the IP substation relay.
VPA Power Amplifier
Amplifier controlled by VOX
The amplifier has VOX detection, and will mute the Background music, when it detects incoming audio.
No programming is required.
Amplifier controlled by relay
A relay can trigger a pre-warning chime signal in front of a message. The audio is connected to the amplifier in the same way as the above alternative.