Billing Installation Guide
From Zenitel Wiki
Billing version 2 is only supported on Alphacom XE platform and requires the board support package version 30.00 of the AMC IP Card.
Steps in short:
- Perform a "GET ALL" with the minimum version AlphaPro v11.00
- Flash latest image on the AMC IP Card
- Insert the new license including billing
- Install the latest APKG package
- Restore
- Enable the Billing Node Exchange in AlphaPro in netrouting for SIP node
- Save the billing version 1 into to filesystem using WinSCP
= To install or upgrade from the billing version 1 to 2 or install Billing ver 2, follow the instructions below =::
Contents
Perform A "Get ALL" with minimum AlphaPro ver 11.00 to Backup the AlphaPro Database before Proceeding
Flash the latest image with support for BSP 30.00 with Alpha Image Upgrade Application
Install the latest image (axeu_b3000_a1100300.aimg) with Alpha Image Upgrade Application.
Flash the latest image with support for BSP 30.00 with Alpha Image Upgrade Application
Install the latest image (axeu_b3000_a1100300.aimg) with Alpha Image Upgrade Application.
2. Install the "Alphacom Flash Image Upgrade" application on your computer (Requires .NET Framework 3.0)
3. Copy the image file "alpha_uimage_20_billing.bin" (or desired image) to the "ServerRoot" catalogue selected while installing the program (default: C:\Program Files\STENTOFON\AlphaImageUpgrade\ServerRoot)
4. Install the new image file according to the AMC Flash Image Update Procedure.
5. If it exists a newer Billing package version that you want to install, do this before configuring the billing system. (alpha_billing_01_10.tbz2 is the latest release by 01.03.2009)
6. Insert a license key with desired SIP Trunk Lines
7. Enable the Billing Node Exchange under "Exchange & System -> NetRouting -> General Settings -> Billing Node"
8. Send Changes, and reset from AlphaPro to update database configuration in the Billing Web interface.