Actions

Network Interface Configuration (Zenitel Connect Pro)

From Zenitel Wiki

ZCP IconPlatf.PNG

Introduction

Network Interface configuration is done from the tile Networks in the System section.

An ICX-510 has two network interfaces which can be configured, a Virtual Machine has minimum of one network interface.

ZCP Network.PNG
Network configuration


ICX-510 - default configuration

The two network interface of the ICX-510 are labeled Eth0 and Eth1. The default configuration is:

  • Eth0: Static IP-address: 169.254.1.5/16
  • Eth1: DHCP
Note icon All IP addresses are given in CIDR notation


Virtual Machine - default configuration

A Virtual Machine may have multiple network interfaces. All interface are configured as DHCP.


Network interface options

Each network interface has 3 main settings which can be selected:

  • DHCP
  • Static
    • IP-address
    • Gateway IP-address
    • DNS
    • Alternate DNS

The Server Hostname is common to all interfaces and only needs to be set for one interface.


The current status of the selected ethernet interface is displayed:

ZCP NetworkCurrent.PNG
Current configuration
  • IPv4 Address: Current IP-address of the interface. This may be different from the setting in the IP-address field, if the new setting has not been saved yet. If the port is not connected it will show as status Disconnected
  • Hardware Address: The MAC-address of the interface

Homepage (Zenitel Connect Pro)