STATUS REPORT
From Zenitel Wiki
| STATUS_REPORT | 0x0072 | 114 | AMC 07.30 | |
|---|---|---|---|---|
| Report equipment Presence and Error/OK status for Subscriber Lines, Audio Links, Devices, Boards, etc. Intended for remote logging and external monitoring systems.
As the message is very general, the message definition will be followed by a detailed example of how the different parameters are used for each “entity” type. Unused parameters/flags are always set to 0. AlphaCom can be programmed to forward STATUS_REPORT messages to two addresses. See Exchange_&_System_(AlphaPro)#Logs_and_Errors, "System Log and Error Reports to". | ||||
| 1 | NET_OBJ_REF {ECL_STATION, ECL_AUDIO_RING, ECL_AUDIO_LINK, ECL_BOARD, ECL_DEVICE, ECL_NODE} |
Entity Reference to the Station / InterExchange Link / ICC Audio Ring / Board / Device / Exchange the status message is for. The entity number is a logical number, e.g. station from 1 to 552. | ||
| 2 | NET_OBJ_REF {NRF_PHYS_ADDR} |
Physical address for the entity defined in parameter 1. This is a hardware module/board/port type of information. | ||
| 3 | BITMAP[1..8] | (Error) State Flags. Bit 1 = Interface present: Bit 2 = Interface test: Bit 4 = Signaling test: Bit 6 = Audio test: Bit 7 = Device dependent test |
Board present in exchange Board reports entity missing/down Last signaling test failed Last audio (tone) test failed | |
| 4 | BITMAP[1..8] | (State) Change Flags. Each bit is set if the corresponding state flag bit was changed from the previous report and cleared if it was unchanged. | ||
| 5 | BITMAP[1..8] | Reporting Flags. Bit 8 = VERBOSE. The report is from a manually/externally started test, where the user wants a complete report. | ||
| 6 | UINT1 | Extra (Error) Status Information 1. | ||
| 7 | UINT1 | Extra (Error) Status Information 2. | ||
| 8 | NET_OBJ_REF (optional) |
Entity Information field 1. . | ||
| STATUS_REPORT for Stations: | ||||
| 1 | NET_OBJ_REF | Station from 1 to 552. The Sub Class field specifies the type of station interface (TouchLine, Telephone). Status info. can have different meaning for each Sub Class. | ||
| 2 | NET_OBJ_REF | Physical address: Module/board/port. The (Implicit Type) Resource Address format is used | ||
| 3 | BITMAP[1..8] | (Error) State Flags. Bit 1 = Interface present: Bit 2 = Interface test: Bit 6 = Audio test: Bit 7 = Device dep. test: |
---What is reported for Stations:--- ASLT/ATLB board missing ASLT/ATLB wire monitoring Tone Test Handset Off-Hook timeout |
(no active report) (only failures) (only changes) (only failures) |
| 5 | BITMAP[1..8] | Reporting Flags. Bit 8 = VERBOSE. |
Set by Tone Test started from station. | |
| 6 | UINT1 | Status information 1. | Bits describing ab- and cd- wire errors | |
| 7 | UINT1 | Status information 2. | TouchLine: Tone test signal/noise value. Telephone: Wire monitor current. | |
| 8 | NET_OBJ_REF | Entity Information field 1 | Directory Number. | |