Difference between revisions of "1-1a. Exchange startup (solution)"
From Zenitel Wiki
(→Related articles) |
|||
| Line 3: | Line 3: | ||
__NOTOC__ | __NOTOC__ | ||
| − | ===Cards | + | ===Cards=== |
*Insert the [[ASLT]] card in position 1. | *Insert the [[ASLT]] card in position 1. | ||
*Insert the [[AMC-IP]] card in position 7. | *Insert the [[AMC-IP]] card in position 7. | ||
| − | ===Power | + | ===Power=== |
*Connect the power source to the plug on the back of the exchange, marked '''''24 VAC IN''''' | *Connect the power source to the plug on the back of the exchange, marked '''''24 VAC IN''''' | ||
*Connect the mains cable to the wall outlet | *Connect the mains cable to the wall outlet | ||
*Observe the exchange starting | *Observe the exchange starting | ||
| − | ===Coldstart | + | ===Coldstart=== |
*Press and hold the [[Autoload|coldstart]] button on the AMC-IP board | *Press and hold the [[Autoload|coldstart]] button on the AMC-IP board | ||
*Press the reset button on the power card briefly | *Press the reset button on the power card briefly | ||
Revision as of 16:53, 16 March 2011
Cards
Power
- Connect the power source to the plug on the back of the exchange, marked 24 VAC IN
- Connect the mains cable to the wall outlet
- Observe the exchange starting
Coldstart
- Press and hold the coldstart button on the AMC-IP board
- Press the reset button on the power card briefly
- Keep the cold start button pressed at least 2 sec. after reset.
- The AMC status LED will blink green when the boot is ready.