Group Call - Increased volume

This article describes how to increase the volume of a group call announcement. The volume is set back to default value when the group call is ended.

Note: This event is CPU extensive. Maximum members in a group using this feature should not exceed approx. 50 stations.

Minimum software is AMC version 11.

In the following example the volume will be set to level 6 when group call 86 is called from stations in UDP group 2. The volume is set to level 3 (default) when the group call is ended.

In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event (the action strings can be copy/paste into AlphaPro):

---

Event Owner:	Stations with UDP: Id: 2
Event type:	08 - Conversation Outgoing
Sub event:	0
When change to:	ON or OFF
When related to:	Directory Number, Id: 86
Action:

IF %chg(1,0)
tmp 0 "%gns(%2.phy,0)"
LOOP
IF %op(%tmp(0),=,0)
STOP
ENDIF
$VOL N%tmp(0) U6
tmp 0 "%gns(%2.phy, %tmp(0))"
ENDLOOP
stop
ENDIF
tmp 0 "%gns(%2.phy,0)"
LOOP
IF %op(%tmp(0),=,0)
STOP
ENDIF
$VOL N%tmp(0) U3
tmp 0 "%gns(%2.phy, %tmp(0))"
ENDLOOP

In the action strings above, there are two lines that defines the volume. Volume during group call is set to 6 (U6):

$VOL N%tmp(0) U6

Volume is set to 3 (U3) when the group call is ended:

$VOL N%tmp(0) U3

U6 and U3 can be changed to other values if required.

Note that there is a standard feature, which might be a better alternative: Group calls with "Setup Priority = Alarm" will automatically use the Volume Override feature of the AlphaCom, without any additional configuration required.