Difference between revisions of "Hot-plug"
From Zenitel Wiki
| Line 1: | Line 1: | ||
{{stub}} | {{stub}} | ||
| − | [[Image:Hot-Plug.jpg|left| | + | [[Image:Hot-Plug.jpg|left|100px|thumb]] |
In E20 and E26 exchanges, all boards may be inserted or removed | In E20 and E26 exchanges, all boards may be inserted or removed | ||
without switching off the power by inserting the powered RJ45 plug | without switching off the power by inserting the powered RJ45 plug | ||
Revision as of 14:47, 15 August 2007
In E20 and E26 exchanges, all boards may be inserted or removed without switching off the power by inserting the powered RJ45 plug from the APC board in the hot-plug receptor found at the top of all cards prior to removal or insertion.
- Remove the hot-plug when the board is in place.
In an E7 exchange, the power must be switched off prior to removal or insertion of boards as this exchange does not have the APC board or hot-plug feature.
- Note! It is strongly recommended to wear a grounded wrist strap
when handling electronic boards to avoid electrostatic discharges that may seriously damage the electronic circuits!