Difference between revisions of "INCA Station Restore Factory Defaults"

Revision as of 11:41, 24 October 2016

An IP Station may have to be reset to its original factory default settings if, for instance, the password to the webserver is forgotten.

The defaults can be either be set to Static IP or Activated DHCP (when there are many new IP Substations in an installation).

This procedure is the recommended procedure for all IP Stations without Display:

The procedure can also be applied to:

The IP Substation Kit - 1008090200 if a button is connected to Input 1.
The IP Dual Display - 1008007000 by using the Privacy button. (In the procedure below, use the Privacy button when the procedure says "Call button").

The Factory Default procedure can be used to either set the station to use a Static IP address, or to use IP address from a DHCP server.

While pressing the call button, power up the substation.
When the substation LED starts blinking, release the call button after exactly 2 blinks.
Let the LED blink for exactly 2 more times, then press the button again.
Keep the button pressed until the LED blinks fast 2 times indicating a successful reset with static IP.
Release the button and the substation will restart with the factory default settings.

Factory default values:

The DHCP option is available from software version 01.07.

While pressing the call button, power up the substation.
When the substation LED starts blinking, release the call button after exactly 2 blinks.
Let the LED blink for exactly 4 more times, then press the button again.
Keep the button pressed until the LED blinks fast 4 times indicating a successful reset with activated DHCP.
Release the button and the substation will restart with the factory default settings.

Factory default values:

@@ Line 44: / Line 44: @@
 * Password: '''alphaadmin''' (Software 01.06 and earlier: '''alphacom''')
 <br/>
-== Restore to Factory Default for IP Stations without Display and Key ==
-* IP Speaker - [[IP Ceiling Loudspeaker - 1401002100|1401002100]]/[[IP Horn Loudspeaker - 1401002500|1401002500]]
-* IP Heavy Duty - [[IP Heavy Duty Station - 1008072200|1008072200]]
-* IP Substation Kit - [[IP Substation Kit - 1008090200|1008090200]]
-The procedure can be used on the IP Substation Kit - 1008090200 an on the IP Master Station Kit - 1008093000.
-<br/>
-The Factory Default can be either set to Static IP 169.254.1.100 or activate DHCP.<br/>
-[[File:Load Defaults without KEY.PNG|left]]
-* Connect a push button ('''KEY1''') between pin 1 and 4 on the P4 connector.
-* Press the button, and power up the substation
-* Keep the button pressed. Release the call button after exactly 2 blinks of the LED
-* Let the LED blink for exactly 2 (Static IP) or 4 times (DHCP), then press the button again
-* Keep the button pressed until it confirms successful factory reset by 2 (Static IP) or 4 (DHCP) fast blinks of the LED
 [[Category: INCA - Restore Factory Defaults and Software Upgrade]]