INCA Station Restore Factory Defaults

This procedure is applicable for the stations:

• IP Substations - 1008041100/1008051000
• IP Video Door Stations - 1401110100/1401110200

This procedure is also applicable for the kits. This requires that a push button is connected between pin 1 and pin 4 on connector P4.

• IP Master Station Kit - 1008093000
• The IP Substation Kit - 1008090200

Kits require a push button to be connected between pins 1 and 4

The unit can be set to use either Static IP or DHCP. Pay attention to the call LED during the restore procedure:

1. While pressing the call button, power up the station and keep the button pressed.
2. Release the button after exactly 2 flashes of the LED.
3. Let the LED flash for exactly 2 more times (Static IP) or exactly 4 more times (DHCP), then press the button again.
4. Keep the button pressed until the LED flashes fast 2 times (Static IP) or flashes fast 4 times (DHCP) indicating a successful reset.
5. Release the button and the station will restart with the factory default settings.

Factory default values:

• Station Mode: Pulse
• Station IP address: 169.254.1.100 or DHCP
• Username: admin
• Password: alphaadmin

* Software 01.06 and earlier: ADMIN/alphacom)