Difference between revisions of "IND - Indicator control for CRMIV LEDs, buzzer etc."
From Zenitel Wiki
Line 2: | Line 2: | ||
The following stations are currently using the IND command: | The following stations are currently using the IND command: | ||
− | * [[CRM IV]]: Control the LED's in the DAK keys, the internal buzzer or relay, and the backlight of the display | + | * [[Control Room Master IV|CRM IV]]: Control the LED's in the DAK keys, the internal buzzer or relay, and the backlight of the display |
− | * DualDisplay station | + | * [[Dual Display Station - 1007007000|DualDisplay station]]: Control the video-state of the DAK-display |
− | * Priscom station | + | * [[Tamper and Vandal Proof Station - 1007063000|Priscom station]]: Control the outputs used for lamps, cell light, call LED and spare output |
+ | |||
, buzzer and LEDs are controlled by an action command called "IND" (INDication). | , buzzer and LEDs are controlled by an action command called "IND" (INDication). | ||
The command syntax is the same for all types of indications: | The command syntax is the same for all types of indications: |
Revision as of 23:09, 10 November 2007
The IND (INDication) action is used for sending commands to a station. The commands are sent as display data.
The following stations are currently using the IND command:
- CRM IV: Control the LED's in the DAK keys, the internal buzzer or relay, and the backlight of the display
- DualDisplay station: Control the video-state of the DAK-display
- Priscom station: Control the outputs used for lamps, cell light, call LED and spare output
, buzzer and LEDs are controlled by an action command called "IND" (INDication). The command syntax is the same for all types of indications:
IND <station phys.no> <key no.> <LED no/buzzer> <Ind-type> [state]
Parameter description
Between the command parameters, there must always be a space.
station phys.no:
- 1-552 = The physical number of the station
key no.:
- 1-100 = The key number of the DAK-key
- 1023 = Buzzer
- 1024 = Display
- 1-100 = The key number of the DAK-key
Led no/buzzer:
- If the previous parameter was DAK-key (1 - 100):
- 1 = Red LED
- 2 = Green LED
- If the previous parameter was Buzzer (1023):
- 1 = Internal buzzer
- 2 = External buzzer (relay)
- If the previous parameter was Display (1024):
- 1 = Backlight
Ind-type:
- LEDs and display:
- 1 = continuous (low priority)
- 2 = slow flash (medium priority)
- 3 = fast flash (high priority)
- Buzzers:
- 1 = 1 bleep per 8 seconds (low priority)
- 2 = 1 bleep per 2 seconds (medium priority)
- 3 = 4 bleeps per second (high priority)
- 4 = continuous (alarm priority)
[state]:
- The brackets [ ] indicate that this command is optional. If nothing is entered in this field, the indication is switched on/off along with the event. By entering OFF, for example, you can set an indication to turn off when the event turns on.
- ON or OFF (capital letters)
Example
IND 2 23 2 3 ON – Station 2, key 23, turn green led, fast flashing, ON