Difference between revisions of "IP Substation Indication LEDs"
From Zenitel Wiki
Line 24: | Line 24: | ||
== LAN LEDs (on LAN and AUX RJ45-jacks) == | == LAN LEDs (on LAN and AUX RJ45-jacks) == | ||
'''Left green LED''': | '''Left green LED''': | ||
− | * Steady light | + | * Steady light: Ethernet connection OK |
− | * Blinking | + | * Blinking: Ethernet traffic |
− | * No light | + | * No light: No Ethernet connection |
'''Right amber LED''': | '''Right amber LED''': | ||
− | * Light | + | * Light: 100 Mbit Ethernet connection |
− | * No light | + | * No light: 10 Mbit Ethernet connection |
[[Category: Stations]] | [[Category: Stations]] | ||
[[Category: IP Stations]] | [[Category: IP Stations]] |
Revision as of 22:45, 10 October 2007
Station LED (on board and in front plate)
Blinking at 1 second interval: Station does not have connection to the AlphaCom E exchange.
- Possible reasons:
- No connection to Ethernet
- Wrong AlphaCom E IP address configured
- Invalid IP address
- No or wrong gateway to the AlphaCom E exchange
Blinking at 5 seconds interval: Station has connection to the AlphaCom E exchange, but has not been registered.
- Reason:
- Station has not been programmed in AlphaPro
No blinking
- Possible reasons:
- Station connected and registered to the AlphaCom E exchange - All OK
- Station not powered up (if no other LEDs are active)
Status LED
- Blinking 2 red + 1 green: Station does not have connection to the AlphaCom E exchange
- Blinking 1 red + 2 green:Station has connection to AlphaCom E exchange, but has not been registered
- Blinking 3 green: Station connected and registered in the AlphaCom E exchange
LAN LEDs (on LAN and AUX RJ45-jacks)
Left green LED:
- Steady light: Ethernet connection OK
- Blinking: Ethernet traffic
- No light: No Ethernet connection
Right amber LED:
- Light: 100 Mbit Ethernet connection
- No light: 10 Mbit Ethernet connection