Difference between revisions of "RCI CHANGED"
From Zenitel Wiki
| (4 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{AI}} | ||
{| border="1" | {| border="1" | ||
|- | |- | ||
| Line 4: | Line 5: | ||
!style="background:#ffdead;" width="100pt"|0x0084 | !style="background:#ffdead;" width="100pt"|0x0084 | ||
!style="background:#ffdead;" width="30pt"|132 | !style="background:#ffdead;" width="30pt"|132 | ||
| − | !style="background:#ffdead; | + | !style="background:#ffdead;" |AMC 08.10 |
|- | |- | ||
|colspan="5"|'''$RCIC W1 U1''' | |colspan="5"|'''$RCIC W1 U1''' | ||
|- | |- | ||
| − | |colspan="5"|New [[RCI]] pin state reported from exchange.<br | + | |colspan="5"|New [[RCI]] pin state reported from exchange.<br />Note: Message is NOT sent automatically from exchange. Must be configured in [[RCI]] table as “side effect” of [[RCI]] actions. Tip: Send [[EVENT_REPORT]] to Event Handler, then you can use a long action string. |
|- | |- | ||
|align=center|1||[[UINT2]]||colspan="3"|Input number | |align=center|1||[[UINT2]]||colspan="3"|Input number | ||
|- | |- | ||
| − | |align=center|2||[[UINT1]]||colspan="3"|Change to state: <br | + | |align=center|2||[[UINT1]]||colspan="3"|Change to state: <br />0 = pin is off<br />1 = pin is on |
|- | |- | ||
|} | |} | ||
| Line 18: | Line 19: | ||
[[AlphaNet_Data_Protocol#Remote_Control|Back to AlphaNet message list]] | [[AlphaNet_Data_Protocol#Remote_Control|Back to AlphaNet message list]] | ||
| + | |||
| + | [[Category: ACDP messages]] | ||
Latest revision as of 16:04, 3 October 2019
| RCI_CHANGED | 0x0084 | 132 | AMC 08.10 | |
|---|---|---|---|---|
| $RCIC W1 U1 | ||||
| New RCI pin state reported from exchange. Note: Message is NOT sent automatically from exchange. Must be configured in RCI table as “side effect” of RCI actions. Tip: Send EVENT_REPORT to Event Handler, then you can use a long action string. | ||||
| 1 | UINT2 | Input number | ||
| 2 | UINT1 | Change to state: 0 = pin is off 1 = pin is on | ||