Difference between revisions of "Remote setup of Alarm message feature"

Revision as of 17:53, 25 January 2008

Feature:	Remote setup of Alarm Message
Default directory number:	761
Feature number:	68
Parameter 1:	0 (N/A)
Description:	Remotely activate playback of alarm message to another station or group of stations. The feature requires ASVP board. Procedure: 761 + group + alarm message 761 + 85 + 8191: Turn on alarm message 8191 to stations in group 85 761 + 85 + 8190: Turn off alarm message to stations in group 85 Alarm messages can also be triggered from the Event Handler or RCI by using the commands AMS or AMG, or the AlphaCom Data Protocol command $ALRM By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions. This must be done from the nvram editor in the TST console.

|- |colspan="2"|Play alarm message on group of stations.

Dial: <dir.no> <group dir.no> |- |}

@@ Line 15: / Line 15: @@
 * 761 + 85 + 8191: Turn on alarm message 8191 to stations in group 85
 * 761 + 85 + 8190: Turn off alarm message to stations in group 85
+<br>
+Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]]
+<br>
+By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions. This must be done from the nvram editor in the [[TST console]].
-By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions. This must be done from the nvram editor in the [[TST console]].
-Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]]
 |}