Difference between revisions of "Zenitel Client IMT Configuration"
From Zenitel Wiki
(Created page with "{{EP}} In the special case of using VS-SDK for a Pulse-enabled project, VS-Client must be configured from the VS-IMT (Intercom Management Tool). The following settings are co...") |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{EP}} | {{EP}} | ||
| − | In the special case of using VS-SDK for a Pulse-enabled project, | + | In the special case of using VS-SDK for a Pulse-enabled project, Zenitel Client must be configured from the VS-IMT (Intercom Management Tool). The following settings are configurable: |
* '''General Settings''': Directory Number, Display Name (Nickname on network), Server IP. | * '''General Settings''': Directory Number, Display Name (Nickname on network), Server IP. | ||
* '''Audio Settings''': Speaker and Microphone volume, Noise cancellation, Audio profile, Conversation mode. | * '''Audio Settings''': Speaker and Microphone volume, Noise cancellation, Audio profile, Conversation mode. | ||
| Line 6: | Line 6: | ||
* '''Other Settings''': Username and password. | * '''Other Settings''': Username and password. | ||
See [[VS-IMT VS-SDK for Pulse System Setup]] for further details. | See [[VS-IMT VS-SDK for Pulse System Setup]] for further details. | ||
| − | [[File:VS-Client IMT.PNG|thumb|500x500px| | + | [[File:VS-Client IMT.PNG|thumb|500x500px|IMT Configuration of Zenitel Client|none]] |
| − | This type of configuration should only be used if VS-SDK for Pulse is needed in the system. The standard way of configuring the | + | This type of configuration should only be used if VS-SDK for Pulse is needed in the system. The standard way of configuring the Zenitel Client is via the application’s '''Account''' settings and station web interface on the [[Edge Controller|IC-Edge Controller]] or Pulse Server device. |
Note that ''Vingtor Stentofon ZAP Service'' needs to be running for this type of configuration. See [[Zenitel Client Installer]] for instructions about how to install ''Vingtor Stentofon ZAP Service.'' | Note that ''Vingtor Stentofon ZAP Service'' needs to be running for this type of configuration. See [[Zenitel Client Installer]] for instructions about how to install ''Vingtor Stentofon ZAP Service.'' | ||
| − | [[Category: | + | [[Category:Zenitel Client]] |
Latest revision as of 14:55, 3 March 2022
In the special case of using VS-SDK for a Pulse-enabled project, Zenitel Client must be configured from the VS-IMT (Intercom Management Tool). The following settings are configurable:
- General Settings: Directory Number, Display Name (Nickname on network), Server IP.
- Audio Settings: Speaker and Microphone volume, Noise cancellation, Audio profile, Conversation mode.
- Call Settings: Auto answer can be enabled.
- Other Settings: Username and password.
See VS-IMT VS-SDK for Pulse System Setup for further details.
This type of configuration should only be used if VS-SDK for Pulse is needed in the system. The standard way of configuring the Zenitel Client is via the application’s Account settings and station web interface on the IC-Edge Controller or Pulse Server device.
Note that Vingtor Stentofon ZAP Service needs to be running for this type of configuration. See Zenitel Client Installer for instructions about how to install Vingtor Stentofon ZAP Service.